7.2 Select Simulations Tab
The Simulations Tab is used to control the trainee’s
experience. Launching scenarios, enabling heat
and enabling teleport are all controlled within this
tab.
Under the Simulations Tab there is a list of all
installed scenarios. Once selected, the user can
then click ‘Run’ to launch the selected scenario.
Scenarios may take up to 20 seconds to launch.
To end the current scenario, push ‘Stop’.
Also on the Simulation Tab are the instructor
controls that enable/disable teleport and enable/
disable the heat suit temperature output.
Pump Pressure
Pump pressure and by extension, hose force can
be controlled by the Pump Pressure. Default pump
pressures are 400kPa, 550kPa and 700kPa. Note
that when 700kPa is selected there is significant
force applied to the user and this setting should
not be used for more than a few minutes. The
hose reel system is not designed for long duration
operation at 700kPa.
Figure 36:
Select Simulation Scenario
Figure 37:
Select Teleport Mode and
Select Heat Vest Mode
Figure 38:
Select Pump Pressure
28
