FIVE OCEANS ATLANTIC 600, Руководство пользователя

Страница: 7 / 20

7
FIVE OCEANS ATLANTIC SERIES
4.7 Under deck fastening 4.7 Under deck fastening
1. Fit windlass to deck. Trim the studs back to 3/16” or 1/4” (5mm or 6mm) below the fully
tightened nuts to prevent snagging anchor rope/chain if necessary.
• NOTE: If using silicone or other rubbery type sealant, it is advisable to allow curing of the
sealant before final tightening of the mounting nuts.
4.8 Loading rope/chain 4.8 Loading rope/chain
For safety and performance Five Oceans recommends the use of matched Five Oceans anchor
rodes.
5- Electrical wiring 5- Electrical wiring
5.1 Electric cable selection 5.1 Electric cable selection
Five Oceans recommends the installer source and install cable that meets the requirements of
the standards and regulations relevant to the installation and codes of practice.
The cable table gives recommended cable sizes based on total length of cable required, from
the battery, following the route of the cables.
CABLE SIZING FOR LENGTH OF CABLE RUN
1. Pull out control arm.
2. Feed anchor rope/chain into entry hole. Tie off to suitable strong point in the anchor locker.
3. Align rope/chain in gypsy. Release control arm and wrap rope/chain around gypsy.
4. Turn on the breaker and power load rest of anchor rope/chain.
Windlass performance is directly related to cable size and length. Voltage drop over the
complete wiring run must not exceed 10%.
DO NOT use a permanent
adhesive/sealant eg.5200
WARNING! Isolate (turn off) the
windlass using circuit breaker / isolator.
Atlantic 600
6 AWG (16 mm²)
2 AWG (25 mm²)
Atlantic 900
2 AWG (25 mm²)
1 AWG (35 mm²)
MODEL
up to 24 ft (up to 8 m)
24 - 50 ft (8 - 16 m)
DO NOT confuse cable length
with the length of the vessel
3/16
"
5mm
6mm 1/4
"