--------
5
--------
ASSEMBLY INSTRUCTIONS
CARE & STORAGE INSTRUCTIONS
Occasionally our products contain components that are pre-lubricated at the
factory. We recommend that you protect flooring, or anything else the parts
may contact, with newspaper or cloth.
NOTE: All location references, such as front, rear, left or right, made in
these instructions are from the user standing behind the Headrest and facing
the Foot Rest Bar Assembly.
Fig. 1a
Fig. 1b
1a.
Remove the Knobs from Poly Bag. Lift the Foot Rest Bar
Assembly to the upright position, as shown in Fig 1a. Then
secure it with the Knobs. Make sure they are fully inserted
and tightened.
Attaching Optional Push Up Bar Assembly:
Place the
Push Up Bar Assembly onto the Foot Rest Bar Assembly
and secure with the Small Hitch Pins that are attached to
the Push Up Bar Assembly. Make sure they are fully
inserted and stay in place.
1b.
Remove the Pins from the Pulley Arm Assemblies. Lift the
Pulley Arm Assembly to an upright position as shown in
Fig 1b. Replace the Large Hitch Pins. Make sure Large
Hitch Pins are fully inserted and stay in place.
SETUP IS NOW COMPLETE.
IMPORTANT: Please read this owner’s manual before beginning your workout for
important instructions on how to use your Pilates Power Gym
TM
exerciser.
•
Keep your unit clean
. Wipe sweat, dust or other
residue off the Frame, Glideboard, Foot Rest and
Handles with a soft, clean cloth after each use.
•
Store your unit after use.
It’s a good idea to store
your equipment in a space away from children and
high traffic areas. The Pilates Power Gym™ is light
and easy to store. To store your Pilates Power
Gym™ exerciser, simply return it to the same state
as you first received it. First, lower the Glideboard to
its flat position. Remove Push Up Bar Assembly
(if attached) by removing the Small Hitch Pins from
both sides of the Push Up Bar Assembly. Remove
the Large Hitch Pins from Pulley Arm Assembly and
lower (Fig. 1b). Replace Large Hitch Pins. Remove
Knobs from Foot Rest Bar Assembly and lower it
toward the Glideboard. Replace Knobs.
Your Pilates Power Gym™ can now be rolled away
for storage by lifting. It is recommended that you
store your Pilates Power Gym™ exerciser in a
horizontal position only. DO NOT store your
equipment vertically. To move, use slow controlled
movements. Lift the rear of the Base Frame
Assembly by grasping the Transport Handle and
lifting until wheels engage with the floor and roll to
desired location.
•
Maintenance.
Periodically check for signs of wear or
fraying of cables, bands, pulleys and wheels.
If you notice any wear, stop using equipment
immediately.
Call our Parts Department to order
replacement parts. Refer to page 4, Ordering
Replacement Parts.
Your Pilates Power Gym
™
exerciser has been carefully
designed to require minimum maintenance.
To ensure this, we recommend that you do the
following:
Optional
FRONT
Knob
Foot Rest Bar
Assembly
Foot
Rest Bar
Assembly
Push Up
Bar Assembly
Pulley Arm
Assemblies
Large
Hitch
Pin
Knob
REAR
Large
Hitch
Pin
Small
Hitch Pin
Small
Hitch Pin
Transport Handle
wheels
Moving and Storage of Unit