Fisher FVH-T610, Руководство по эксплуатации

Страница: 41 / 42

TROUBLESHOOTING GUIDE
If you have followed the instructions in this manual and still have difficulty operating your VCR, check the steps below
before getting help from a factory-authorized service center.
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
No power. œ The power cord is not connected. œ Connect the power cord to the AC
power input socket, then to an AC wall
outlet.
œ
The power is not on.
œ
Turn the power on.
The “Auto Setup” message is
displayed when the power is
turned on. œ The VCR is being used for the first
time or after the power has failed or
has been disconnected for more than
5 seconds. œ The VCR is not set or the settings
have been erased from the memory.
Please refer to INITIAL SETUP to set
the VCR.
Timer recording does not
function.
œ
The clock is not set correctly.
œ
Set the clock correctly.
œ The program timer is set incorrectly. œ Set the program timer correctly.
œ
The timer is not set to ON.
œ
Turn the power off. The timer icon (
n
)
appears.
Recording is not possible. œ The record safety tab on the cassette
is missing. œ Place vinyl tape over the safety tab
hole in the cassette.
œ
The channel selected on the VCR
does not correspond to the cable
converter/decoder output channel.
œ
Select the correct channel
(CH 02 ~ 07).
The picture is poor during
playback. œ The TV channel selector is not set to
the proper channel. œ During playback, set the TV’s channel
selector to channel 3 or 4 to match the
VCR’s channel switch setting.
œ The TV fine tuning is not set correctly. œ Fine-tune the TV.
œ
If the playback picture is still poor,
contact a factory-authorized service
center.
White lines (noise bands) in
the picture during playback. œ Poor quality recording or tape. œ Try a different tape.
No picture during playback.
œ
The TV is not set to the proper channel.
œ
Set the TV’s channel selector to match
the VCR’s channel switch setting
(channel 3 or 4).
Playback picture is partially
noisy. (horizontal white lines)
œ
The tracking control is not set to the
proper position.
œ
Adjust the tracking control for a better
picture.
TV programs cannot be seen.
œ
The cable connections are incorrect.
œ
Recheck all cable connections.
The remote control does not
operate. œ Temporary problem with the internal
circuitry. œ Remove the batteries from the remote
control for 10 minutes or more, then
reinstall the batteries and try again.
SC4H/UF (FVH-T610 GB) Fri. Jan., 07/2000
40