Fisher & Paykel RF201A, Руководство по обслуживанию

Страница: 58 / 88

819091D
58
6.
Remove the flapper off the bottom hinge and turn over to expose the bottom of the flapper.
7.
Slide the element forward. Note: The element is taped onto the steel insert and may offer some
resistance. Care should be taken not to damage the insert or the product. Refer Photo 12.4.13.4
Pull element enough to expose Molex connector.
8.
Disconnect the Molex connector and remove the entire element.
9. Replacement and re-fitment of the element is in reverse order. Cautionary NOTE: Ensure the
element wiring is routed and/or is not under tension as it may cause early failure of the element.
Refer Photo 12.4.13.5
Photo 12.4.13.5
12.4.18 Refitting Icemaker
1. Refit the sensor to the underneath of the icemaker tray.
2. Refit the wiring connector.
3. Place the harness into the groove on the edge of the body of the icemaker.
4. Locate the clips and align the icemaker to the clips.
5. With an upward pressure, re-clip the icemaker into position.
Note: If either front or rear clips do not re-clip, further pressure will need to be exercised to re-clip
the icemaker.
12.4.19 Icemaker Temperature Sensor Replacement
1. Remove the icemaker (refer to Section 0).
2. The sensor wires are to be cut as close to the sensor as possible. Strip the wires back (10mm)
on the new sensor and on the wiring in the cabinet to allow the wires to be soldered together.
3. Place heat shrink onto both wires of the sensor.
4. Solder the wires, slide the heat shrink over the joints and heat the heat shrink.
12.4.20 Water Valve Replacement
1. Ensure the water is turned off at the supply tap.
2. Disconnect the refrigerator from the power supply.
3. Pull the product away from the wall to access the rear of the product.
4. To remove the water tube from the water valve, push the inner part of the clip inwards and hold
down while pulling the tube from the valve. Drain the water (approximately 1½ litres) into a
container.
5. Remove the RAST connector from the water valve.
6. Remove the two screws holding the valve to the back wall of the unit compartment.
7. Refit in reverse order.