3
Prior to installing your oven, ensure the following:
z
The countertop and oven cavity are square and level, and are the required dimensions.
z
The installation will comply with all clearance requirements and applicable standards
and regulations.
z
The isolating switch will be easily accessible to the customer with the oven installed.
z
The electrician provides sufficient free length of power supply cable to reach from
the bottom rear of the cavity to at least 59 1/16" (1.5m) in front of the bottom edge of
the opening.
z
The cable may enter the cavity from the side, top or bottom, but top entry must be at the
rear of the cavity.
z
The oven connection socket (if fitted) is outside the cavity if the oven is flush to the
rear wall.
z
The oven will rest on a surface that can support its weight.
z
The height from the floor suits the customer.
z
You consult local building authorities and by-laws if in doubt regarding installation.
WARNING!
Some environmental factors and cooking habits can cause condensation in and around
the oven during use. To protect surrounding cabinetry from possible damage caused by
frequent or excessive condensation, we recommend moisture-proofing the oven cavity.
During installation, please ensure the following:
z
The oven door(s) can open fully without obstruction.
z
The power supply cable does not touch any hot metal parts.
z
The isolating switch is easily accessible to the customer with the oven installed.
z
You complete the ‘Final checklist’ at the end of the installation.
z
If, after following the instructions given, correct performance cannot be achieved, please
contact your nearest Fisher & Paykel Service Centre, Customer Care, or contact us through
our local website listed at the end of this document.
WARNING!
Take extra care not to damage the lower trim of the oven during installation. The
trim is important for correct air circulation and allows the door to open and close
without obstruction.
The manufacturer does not accept any responsibility for damage resulting from
incorrect installation.
●
The oven can be installed under a cooktop, in a column, or combined with the companion
warmer drawer or coffee maker.
●
The cabinet material must be able to withstand heat.
●
The oven must be centered within the walls of the cabinet and fixed with the screws that
are provided.
z
Keep all packing materials until the unit has been inspected.
z
Inspect the product to ensure there is no shipping damage. If any damage is detected
contact the dealer or retailer you bought the product from to report the damage.
z
Fisher & Paykel is not responsible for shipping damage.
Supplied
Mounting
screws (2)
Mounting
washers (2)
Not supplied
Crosshead
screwdriver
Power drill
Scissors
Lower trim (1)
Lower trim
screws (2)
PRIOR TO INSTALLATION
DURING INSTALLATION
PARTS SUPPLIED
TOOLS REQUIRED
COMPONENTS REQUIRED
INSTALLATION CONSIDERATIONS
