PARTS SUPPLIED
Clamp (1)
Wire clip (1)
Phillips
16 mm
screws (7)
Top mounting
brackets (2)
OPTIONAL
Drain hose
support (1)
Moisture protection
tape (1)
(to prevent moisture
damage)
Drain hose
joiner (1)
Rubber
washer for
inlet hose (1)
4
5 CAVITY PREPARATION
If the Drain hose supplied is not long enough to reach your services, you
must
use a Drain Hose Extension Kit P/N 525798 which will extend the drain hose by 3.6m. The kit is available from the nearest Fisher & Paykel
Authorised Service Centre or our local website listed at the end of this document.
These marks indicate formed bracket screw locations.
Preferred position. If adequate clearance, services hole can be higher.
If hole is higher, ensure drain hose is routed straight into the waste connection.
Water Connection
Recommended
COLD
(Maximum 60°C).
¾
“ BSP (GB20) to suit flat washer.
Water Pressure
Max
Min
Water softener models
1 MPa (145 psi)
0.1 MPa (14.5 psi)
Other models
1 MPa (145 psi)
0.03 MPa (4.3 psi)
Drains will need to be separated to satisfy kosher requirements.
We suggest you confirm acceptability with your local rabbi in
respect to kosher installations.
*
Note: Se
rvices can be locat
ed
either side of DishDra
wer®.
Important!
Adjacent cabinetry must not
extend above cavity base
220-240 VAC
min. 4.5 A
min.
200 mm
10 mm
max.
450 mm
min. ø
60 mm
Moisture
protection
tape must
be applied.
*
*
Water supply
(2,1) -1- 599683B DD60S installA2 NZGB.indd 6/7/09 11:36:09 AM
(2,1) -1- 599683B DD60S installA2 NZGB.indd 6/7/09 11:36:09 AM
