Fisher & Paykel DH8060P, Инструкции по установке и Руководство пользователя

Страница: 26 / 40

24
CARING FOR YOUR DRYER
Emptying the water collection tank
During the drying cycle steam condenses into water
and is collected in the water tank, located at the top
left of the dryer. It is important to empty the water
tank after every load.
There is an indicator light that will illuminate when
the water tank needs emptying. A user warning
will also be displayed on the screen (refer to the
'Before you call for service' section). If the water
tank becomes full during operation, the dryer will go
into ‘Cool’ mode for several minutes, then pause and
beep to alert you. Empty the tank and touch to
resume the cycle.
Note: you do not need to empty the water tank if
you have set up the drain hose to drain the water
automatically.
To empty the water tank:
1
Remove the water tank by holding onto the handle
and pulling outwards gently to remove it. Ensure
that you keep the tank level when it is being
removed to prevent the water collected from spilling.
2
Pour the water down the sink or into a bucket, and
then put the tank back in place.
IMPORTANT!
● ●
Do not use the water collected in the water tank for drinking or food processing.
● ●
Never run the dryer without the water tank in place unless the drain hose has
been installed.
● ●
If the water tank becomes full, the tumble dryer will pause drying and will sound
an alarm. You must empty the water tank before the dryer can continue drying.
Empty the tank, replace it in the housing then touch to resume the cycle.
Removing the
water collection tank
Tipping out the water
from the condensing tank