478182
39
If this appears you need to set the dispensing type of the LED AquaSmart™:
1. Press and hold down the
TEMPERATURE
button, then press the
POWER
button until
three beeps are heard.
2. Press
the
TEMPERATURE
button to scroll through the ‘dispensing type’ options stopping at
desired ‘dispensing type’ setting.
Cold LED = No Dispensing
Warm LED = Double Dispensing (Detergent & Fabric Softener or Detergent & Bleach)
Hot LED= Triple dispensing (Detergent, Fabric softener & Bleach)
3. Press the
POWER
button to exit and save current setting.
For detailed fault codes (refer to section 8)
7.2 Component
Testing
To select the Component Test Mode:
1. Press and hold the
HI EFFICIENCY
button, then press the
POWER
button until two beeps
are heard.
2. Press
the
SPIN
button until all the spin LEDs are illuminated.
To operate the
:
•
Hot Water Valve
Push the
REGULAR
button.
•
Cold Water Valve
Push the
HEAVY
button.
•
Detergent Valve
Push the
DELICATE
button.
•
Fabric Softener Valve Push the
SHEETS
button
•
Bleach Valve
Push the
WHITES
button.
•
Drain Pump
Push the
BULKY
button.
•
Re-circulating Pump
Push the
EASY IRON
button.
To turn each component off, push the same buttons that were pushed to turn them on.
7.3 Hot Bowl Flag
If the machine has been filled with the hot water valve utilised (i.e. warm or hot fill) and has not had
a cold rinse, the electronics will not allow the machine to spin up to its full speed of 1000 RPM. It
will only allow the spin speed to reach 700 RPM and the
HOT
LED will flash. To remove this flag,
push and hold the
TEMPERATURE
button until the hot LED turns off.
7.4 Restart
Feature
The LED AquaSmart™ leaves the factory with the RESTART turned on.
With the RESTART feature on:
1. If a fault occurs in the machine, the diagnostic system will detect it. However, instead of
displaying a fault code immediately, the machine will try to RESTART.
2. If the fault was only of a temporary nature, the machine will restart and finish the cycle.
3. If there is a continuous fault, the machine will try to RESTART a number of times. This
process could take up to 8 minutes depending on the type of fault. After this, if the machine
still cannot restart, the fault code is displayed and the machine will beep continuously.
Dispensing Model
To turn RESTART off:
•
Enter the COMPONENT TEST MODE by pressing and holding the
HI EFFICIENCY
button,
and then press the power button until two beeps are heard.
•
Press the
SPIN
button until all the spin LEDs are illuminated.
•
Press the
FABRIC SOFTENER
button. The Fabric Softener LED will then be turned off.
•
When the restart feature is turned off the power button will flash when the power is on at
the wall but off at the console, indicating that the restart is in the off mode.
