Mode of Operation of the Generator
Panda PMS AGT-DC 4000 - Chapter A: Mode of Operation of the Generator Page 9
A.4 Betrieb des Generators bei Einbau unter der Wasserlinie
If the generator cannot be installed clearly at least 600mm over the waterline, a vent valve must
be installed into the raw water line. At installation beside the "midship´s line" a possible heeling
must be considered!
The water hose in the sound cover is split on the heat exchanger outlet and extended in each
case in the sound cover at both ends with a connecting nipple by a hose end. Both hose ends
must led out from the sound cover to a point, which is at least for 600mm over the waterline (if
possible in the midship´s line). The valve is inserted at the highest place, at least 600mm over the
waterline.
The tube bend must be removed. Now the
two ends are extended in each case with a
hose and attached at a value of approx.
600mm over the waterline with a ventila-
tion valve.
1)
Hull inlet
2)
Water cock
3)
Reducer
4)
Raw water filter
5)
Raw water pump
6)
Heat exchanger
7)
Fresh water pump
8)
Exhaust manifold, water-cooled
9)
External vent valve
10) Diode block, water-cooled
11) Cooling water tank
