Fischer Panda 4000s PMS FC, Руководство пользователя

Страница: 94 / 140

Installation Instructions
Seite/Page 92 Panda_4000s_PMS_SCB_FCB_eng.R04 - Kapitel/Chapter 5: Installation Instructions 26.1.11
Fig. 5.6.1-4: Starter motor
All Panda generators are equipped with an independent 12V-
DC starter motor. The connecting lines cross-section from the
battery to the DC system should measure 25mm².
1. Solenoid switch for starter motor
2. Starter motor
Sample picture 4000s FC
5.6.1.1 Additional information for battery connection
Attention!:
Commissioning:
Installation of battery lines.
! Consider ABYC regulation E11 AC and DC electrical systems on boats
and/or EN ISO 10133:2000 small watercrafts, electrical systems, low
voltage (DC) systems.
Install a right sized fuse in the positive battery line as close as possible to the
battery, but max 12 inch, 300mm from the battery. The length of the cable to
the fuse, the cable must be protected by a sheath or conduit against damage
of the insulation
Use only cable with self retardant and self extinguishing insulation suitable
for high temperatures up to 195°F, 90°C
Install battery lines in a safe way the cable insulation will not be shaved or
damaged.
Battery poles must be protected against short circuits by error.
Inside the capsule of the Fischer Panda Generator the battery positive line
must be protected against heat and vibration by a suitable conduit or
sheath and must be routed that way it is not touching any area that will get
hot under normal operation like entire engine itself, exhaust elbow and
exhaust manifold or exhaust lines or the V-belt and pulleys. The cable shall
not be to tight otherwise damage will happen
Run the generator carefully after installation and double check, if there is any
possibility for damage of the battery cable. Correct if necessary .
Use multi-core stranded wire only, for the battery connection.
1
2