4
Quick Reference
Valet Mode
When servicing or loaning your vehicle to others, the system should be placed in Valet Mode. Valet
Mode prevents the system from remote starting and disables all alarm functions.
IMPORTANT:
While in
Valet mode the remote will still control power lock and unlock systems. The parking lights will not flash.
The system can be put into valet one of three ways:
1. While holding the foot brake, cycle the key to the Ignition or ‘On’ position and then back to
the ‘Off’ position 5 times within 10 seconds. The parking lights will flash once indicating that
the system has entered Valet Mode.
2. Turn the vehicle’s key to the ignition “on” position, tap the tap the Lock and Trunk butons for a half
second. The parking lights will flash once to confirm valet mode. Repeat this process to exit valet mode.
The parking lights will flash twice confirming valet mode is disabled.
3. Turn the key to the Ignition or ‘On’ position then using a 4 button remote press and release the lock
and trunk buttons together simultaneously for a half second. The vehicle parking lights will flash 1 time to
indicate the system has successfully entered valet mode.
Remote Maintenance
When the battery on your 2 Way remote is low, you will no longer receive 2 Way confirmation in
areas you usually do. Your remote will only send commands to your vehicle. The LED’s on your
2 Way remote will also fade after transmission. The only regular maintenance this system requires is
remote control battery replacement. No programming is required when replacing the battery. If you need
assistance, we recommend contacting your place of purchase.
Two Way Remotes:
Use a quarter or flat head screwdriver to pry open the remote. You can insert the quarter or flat head
screwdriver in the small slot at the bottom of the remote by the keychain loop. Carefully pry off the back
cover without damaging the circuit board. Your battery size should be listed on the sticker on the remote.
(Battery size: 2 x CR2025)
IMPORTANT:
Be sure to observe correct polarity when installing the battery.
One Way Remotes:
Use a quarter or flat head screwdriver to pry open the remote. You can insert the quarter or flat head
screwdriver in the small slot at the bottom of the remote by the keychain loop. Carefully pry off the back
cover using caution that you do not damage the circuit board. Your battery size should be listed on the
sticker on the remote. Battery size: 2 x CR2025)
IMPORTANT:
Be sure to observe correct polarity when
installing the battery.
2 Way Remote Button Functions
Button(s)
Duration
Function
LED Icons
LED Icons – 2
nd
Car Mode
Chirp(s)
Half second
Locks doors and/or arms alarm.
Once
3.5 seconds
Panic/vehicle locater (flashes vehicle’s
parking lights and sounds siren and horn).
N/A
