10
Upon lock/arm and unlock/disarm, you can eliminate vehicle’s audible confirmation by muting the
siren. Normally, the siren will chirp once to indicate the system is locked/armed and twice to
indicate the system is unlocked/disarmed. To mute the siren, tap the Lock and Unlock
buttons simultaneously for a half second.
IMPORTANT:
Your system must be programmed by your
installer before this is available. Even when the siren is muted, it will still sound if the alarm is triggered.
Shock Sensor On/Off
Hold the Lock and Trunk buttons
simultaneously for 2.5 seconds to turn the shock
sensor on and off. The remote will beep twice to confirm the shock sensor is off. The remote will
beep once to confirm the shock sensor is on.
IMPORTANT:
Turning off the shock sensor also
turns off any optional sensors.
FT-DAS
STEP 1:
Turn the ignition to the ‘on’ position.
STEP 2:
2 Way remotes-hold buttons 1 and 2 (Lock and Unlock) for 2.5 seconds. You will get two
parking light flashes. 1 Way remotes-hold Lock and Unlock for 2.5 seconds. You will get two parking light
flashes.
STEP 3:
To set the Warn Away Zone 1, tap button 1. (1 Way: Lock) After you get one parking light flash,
tap the vehicle. You will get siren chirps 1-most sensitive through 10-least sensitive. This sets the impact
sensitivity of Warn Away Zone 1.
Setting Zone 1 will automatically set Zone 2. If you would
like to manually set Zone 2 proceed:
To set Instant Trigger Zone 2, tap button 2. (1 Way: Unlock) After you get two parking light flashes, tap
the vehicle. You will get siren chirps 1-lowest through 10-highest. This sets the impact sensitivity of
Instant Trigger Zone 2.
STEP 4:
Once you get two parking light flashes, you are ready to test your DAS.
FT-Shock
Adjusting the shock sensor sensitivity is done at the actual sensor, which is generally mounted
somewhere under the vehicle’s dashboard. The higher the number on the dial means greater sensitivity
to impact. The recommended dial setting for most vehicles is somewhere between 2 and 4. If you are
testing your sensor, please note that the shock sensor does not recognize impact for 30 seconds after
the system has been armed.
Advanced Features
The following section reviews advanced system functions. Many of these functions require multiple steps
or additional programming by your local authorized dealer.
Antenna LED (ANT-2WFMX and ANT-1WFMX)
The FMX antennas come with a blue LED built in on the rear. This LED flashes when your vehicle is
locked/armed. There is also a green/red LED on the front of your antenna. This green/red LED is used to
program remotes and to turn the flashing blue LED on and off. You can turn the flashing LED on or off
using the following procedure:
