Advanced System Functions
Alarm disarm and unlock
To disarm hold your finger over the ‘Red Circle’ for 2.5 seconds. Once the LEDs start their circular pattern, enter your 4 digit code. (Refer to Step 4
above.) Two seconds after entering the 4th digit, your system will disarm.
2 Way LCD remote paging
To page a 2 Way LCD remote just tap the ‘Red Circle’ twice.
Touch Panel Sensitivity
To change touch sensitivity open the driver’s door, hold the button on the back of the RPS Touch until the LEDs go out. Release button and tap again.
The number of solid LEDs represent sensitivity of touch, 1 being the lowest, 5 the highest.
RPS Touch On or Off
You can turn the RPS Touch off from your remote. Just follow the instructions below:
STEP 1: Enter remote programming mode by holding down the Trunk and Key/Start buttons simultaneously for 2.5 seconds. The remote
will beep once and the LCD will read “REMOTE MENU” indicating that you have entered programming mode.
STEP 2: Scroll through the remote options by taping the Function button . Once the LCD reads “RPS-ON” tap the Lock button to turn this
feature on. The LCD will read “RPS-OFF”
STEP 3: Exit remote programming by holding down the Trunk and Key/Start buttons simultaneously for 2.5 seconds. The remote will beep
indicating that you have successfully exited programming. The vibration icon will remain illuminated on the LCD indicating the remote is in remote
mute/vibration mode.
Advanced System Functions
The new RPS touch has multiple features including: remote paging, 4 digit pin unlock/disarm, and arm/lock. All features are operated with a simple
touch of the sensor.
Please have your installer program Option 3-16 to Setting 2.
RPS Touch and car call functions do not require programming, however in order to unlock/disarm your vehicle you must program a 4 digit passcode
using the instructions below:
STEP 1: Choose your RPS Touch 4 digit code. ‘0’ is not available.
STEP 2: Turn ignition to the ‘ON’ position and leave driver’s door open.
STEP 3: Hold your finger over the ‘Red Circle’ icon for 2.5 seconds.
STEP 4: When the siren chirps and LEDs flash in a circular pattern, tap on your first number. (Hold the number for 2.5 seconds to choose 6 through
10.) After choosing your first number you will get one siren chirp and LEDs will flash in a circular pattern.
STEP 5: Repeat Step 4 until all four digits are set. You will get 1 siren chirp and 1 parking light flash. Repeat Steps 2 - 5 if you get 3 chirps and light
flashes. Your RPS Touch is now programmed.
Alarm rearm and lock
To rearm hold your finger on the ‘Red Circle’ for 2.5 seconds.
RPS Touch (Remote Paging Sensor)
!
!
!
!
By Firstech, LLC 30
31 By Firstech, LLC
2W901R-SS_ES USER GUIDE.indd 31-32
2011-3-26 14:34:19
