First Water Flex-Chlorinator, Руководство по эксплуатации

Страница: 8 / 12

8
Installing the Pump to the Water Motor
1. Lubricate “O” rings on pump
housing with any food grade lubri-
cant when pump is removed from
motor.
NOTE: a light coating of lubricant is
all that is required.
2. Make sure the pump stem is
pulled all the way out (about 2”).
Push the pump up into the water
motor, and turn 1/4 turn clockwise,
port to front.
NOTE: the guide slot must be
aligned to fit into the key on the
inside of the water motor.
3. After installing pump into bottom
of water motor - loosen Jaco nut on
pump and insert hose into fitting.
Re-tighten Jaco nut.
1. Make sure the water is turned
off, and water pressure in the water
motor is released - this is done by
loosening the Air Vent (pressure
relief valve) on the top of the water
motor and turning off the water
flow.
NOTE: Do Not Remove Air Vent.
2. Turn pump counter clockwise
1/4 turn, then pull down.
NOTE: always disconnect hose from
pump before removing.
Removing the Pump from the Water Motor
Pump Maintenance