First Degree Fitness VX Pro, Руководство пользователя

Страница: 14 / 18

14
Fault Probable Cause Solution
Water changes color or
becomes cloudy. Rower is in direct sunlight
or has not had water
treatment. Change rower location to reduce direct
exposure to sunlight. Add water treat-
ment or change tank water as directed
in the water treatment section of this
manual.
Rowing stroke return too
light. Bungee not under enough
tension. Open rear Perspex cover, cut bungee
tie wrap . Tighten by small increments
using the bungee tie off tab point and
test tension by allowing the rowing han-
dle to return to its furthest point forward
while still having some slight tension.
Note light fraying of the bungee cord is
normal.
Rower rocks from side to
side when sitting on floor Front/Rear frame levelers
need adjusting Adjust the front two frame levelers or
rear leg levelers until stability is
reached. Note: It is normal for the low-
er rear leveler to rest slightly off the
floor.
Front of rower lifts slightly
during vigorous rowing. Lower rear frame leveler
too high. Check to see that frame tensioning bolt
is tightened properly. Lower rear frame
leveler should be approx 5mm off the
ground.
Computer screen illumi-
nates, but does not regis-
ter when rowing. Loose or failed connec-
tion/Sensor gap too wide
(see erratic computer dis-
play). Check that the computer lead is con-
nected properly. If connected properly
check sensor gap. Contact your local
service center if this fails to address the
problem.
Rowing stroke feels
lumpy, not smooth.
Dyneema Cable is twist-
ed . You can untwist the Dyneema Cable by
simply pulling the rowing handle to the
end and turning the rowing handle to
untwist the cable.
Note: Light fraying is normal.
The VX-PRO computer
does not illuminate after
battery installation. Batteries installed incor-
rectly or need replacing. Reinstall batteries in correct position
and try again. If the LCD screen fails to
illuminate, try rotating the batteries
slightly in the computer. If this fails,
contact your local service center.
The VX-PRO computer
display is erratic while
displaying SPM and
500meter times. Gap between sensor and
magnetic ring is too wide. Adjust sensor location using rear sliding
adjustment located inside rear Perspex
cover.
Excessive frame flex
during hard rowing. Frame Tension Cable is
too loose Loosen frame tension cable Retaining
nut and tighten cable until taut.
Troubleshooting Guide