21
Troubleshooting
Fault
Probable Cause
Solution
Water changes color or
becomes cloudy.
The Rower is in direct
sunlight or has not had
water treatment.
Change Rower location to
reduce direct exposure to
sunlight. Add water treatment
or change tank water as
directed in the water treatment
section of this manual.
Consider using distilled water to
refill tank.
Rower Belt slipping off
belt/ bungee pulley.
Bungee not under enough
tension.
Tighten Bungee cord following
the instructions in "Replacing
the Bungee/Shock Cord" section
of this manual.
Front of the Rower lifts
slightly during vigorous
rowing.
M10X150mm Vertical
Seat Rail Tensioning Bolt is
slightly too loose.
Tighten bolt 1/2 turn and row
again. Tighten as needed until
problem stops. Note: Over
tightening this bolt can damage
the Seat Rail. Only tighten bolt
in small increments until fault is
corrected.
The Rower Monitor
does not illuminate
after battery
installation.
Batteries installed
incorrectly or need
replacing.
Reinstall batteries in correct
position and try again. If the
LCD screen fails to illuminate,
try rotating the batteries
slightly in the monitor. If this
fails, contact your local service
center.
The Rower Monitor
screen illuminates, but
does not register when
rowing.
Loose or failed connection. Check that the monitor lead
is connected properly. If it is
connected then contact your
local service center.
