18
Reattaching the Rower Belt
Begin reattaching the Rower Belt by
threading around the Rower Belt Pulley
with the Velcro side facing upward as
illustrated.
Next, thread the Belt around the Idle
Wheel as shown. Once around the Idle
Wheel, attach the Rower Belt to the
Belt/Bungee Pulley. There is an obvious
“lip” at the attachment point.
Wind the Rower Belt onto the Belt/Bungee
Pulley until the Rower Handle is as it’s
furthest forward position.
If Bungee Shock Cords previous tension
seemed correct (a good way to judge is
if the Rower Handle can make it to the
furthest point forward on the top of the
Main Frame under bungee tension alone)
then simply tie off at previous position.
If the return is too slack, experiment by
tightening the tension in small increments
and testing until the correct tension is
achieved. If the Rower Handle cannot
reach the end of the Seat Rail during a
rowing stroke, then the Bungee Shock
Cord is over-tensioned.
Hint
Rethread the Bungee Shock Cord (on
opposite side of the Idle Wheel) back
through the Bungee Pulleys and tie off
at the Attachment Point.
Velcro Facing Upward
Idle Wheel
Bungee Shock Cord
Bungee Pulley
Rower Handle
Belt/Bungee Pulley
