First Degree Fitness Neptune Challenge AR, Руководство пользователя

Страница: 16 / 19

16
Removing the Bungee Shock Cord
Bungee Shock Cord
Bungee Pulley
4.Rethread the Bungee Shock Cord (on
opposite side of the Idle Wheel) back
through the Bungee Pulleys and tie off
at the Attachment Point.
Bungee
Shock Cord
Bungee Attachment
Point
Upper Frame Plug
Upper Frame
Hole
Belt/ Bungee
Pulley
move the Rowing Handle to it’s farthest
forward point on the Mainframe, then cut
the plastic end tie and follow the drawing
above for bungee removal. Next, re-
move the Upper Frame Plug to allow the
Bungee Shock Cord to be threaded
through the top of the frame. Note: You
will need to rotate the Belt/Bungee Pulley
to align the holes properly. Should the
belt drop off of during the bungee
change, please refer to the previous pag-
es for “Attaching/Reattaching the Rower
Belt”.
Once Bungee Cord and Upper Frame
Hole are aligned, push the Bungee Cord
up and through the frame as shown
Hint
If Bungee Shock Cords previous tension seemed
correct (a good way to judge is if the Rower Han-
dle can make it to the furthest point forward on
the top of the Mainframe under bungee tension
alone) then simply tie off at previous position. If
the return is too slack, experiment by tightening
the tension in small increments and testing until
the correct tension is achieved. If the Rower Handle cannot reach the end of the
seat rail during a rowing stroke, then the Bungee Shock Cord is over-tensioned.