How to Install Your Smoke Alarm
This smoke alarm is shipped with the battery disconnected. You
MUST properly connect the battery before mounting the smoke
alarm to the wall or ceiling. The smoke alarm will not operate
without the battery first being properly connected.
Read SMOKE ALARM PLACEMENT information on page 3. After you
have selected the locations for the installation of smoke alarms:
1. Unlock and remove mounting plate by turning it counter-clock-
wise. (For tamper-resist option, twist out and set aside the locking
pin molded into the battery compartment of the plastic smoke
alarm base.)
2. Place mounting bracket against ceiling or wall where you wish to
mount the smoke alarm. Use a pencil to trace the inside of the
two mounting hole locations.
3. Drill two holes, using a 3/16 in. (5 mm) drill bit in the centers
of the hole locations and insert anchors into holes.
4. Use mounting screws to secure mounting bracket to ceiling
or wall.
5. Connect new 9-volt battery to battery connector inside battery
pocket. BE SURE BATTERY IS SECURELY CONNECTED. Smoke
alarm may beep briefly when battery is installed. Firmly depress
the test button for ten (10) seconds. The smoke alarm should
sound its alarm horn, indicating the battery is connected properly.
The Quick-Quiet™ Alarm Control feature will activate for a
maximum of 15 minutes after testing.
6. Insert battery into battery pocket.
7. For tamper resist, use long-nosed pliers to remove thin plastic
from notch on smoke alarm edge.
8. Position smoke alarm to mounting bracket and turn clockwise.
The smoke alarm will lock into place. (To engage tamper-resist
feature, insert pin into notch on edge of smoke alarm and
mounting plate.)
NOTE: Smoke alarm will not mount to bracket if battery
is not installed.
9 Test smoke alarm. See TESTING your SMOKE ALARM.
DO NOT connect this smoke alarm to any other detector or
electrical device. Doing so will cause the smoke alarm to
operate improperly or fail to operate.
Testing Your Smoke Alarm
If alarm horn sounds, and smoke alarm is not being tested,
the smoke alarm is sensing smoke. THE SOUND OF THE
ALARM HORN REQUIRES YOUR IMMEDIATE ATTENTION
AND ACTION.
Test each smoke alarm weekly to be sure it is installed correctly and
operating properly.
Test smoke alarms upon returning from vacation. Also test when no
one has been in the household for several days.
Stand at arm’s length from the smoke alarm when testing. The large
test button is shaped so that the end of a broomstick can be used to
test. The alarm horn is loud to alert you to an emergency. The alarm
horn may be harmful to your hearing.
The center test button accurately tests all functions. NEVER use an
open flame from a match or lighter to test this smoke alarm. You may
ignite and set fire to the smoke alarm and your home.
Test all smoke alarms weekly as follows:
1. Look at the LED power indicator. A visual light flashing about once
a minute indicates the smoke alarm is receiving battery power.
See “LED Power/Alarm Indicator” chart.
4
Insert pin here
WARNING
!
Remove thin plastic from notch
WARNING
!
Insert pin here
