FireRock 3620 Avenue C, Руководство по эксплуатации продукта

Страница: 11 / 124

11
Running Bond Stacked Bond Basket Weave Full Herringbone Split Herringbone
FIREROCK ADHESIVE MORTAR
FireRock Adhesive Mortar must be used to install the firebox and FireRock masonry chimney in order for the
FireRock warranty to be valid. It may also be used to install the firebrick, though substitutions are allowed.
Substitutions in the firebox will result in a non-compliant unit and will invalidate the FireRock warranty.
• Weight per bag: 25 lbs
• Bags per pallet: 96 bags
• The appropriate number of bags for each fireplace are included with the installation kit (See page 15)
• Mortar for masonry chimney block must be purchased separately. One bag of mortar is needed for every 6
masonry chimney pieces.
MIXING & USAGE:
• Clean all loose material from surfaces to be mortared
• Mix mortar with water at a low speed to avoid entraining excess air, mix until trowelable consistency
• Apply sufficient amount to surface to ensure 100% coverage is obtained (Joint thickness 1/8” - 3/8” suggested)
• Must use FireRock Adhesive Mortar to erect all FireRock firebox and chimney components
• After setting of a component, the mortar must be able to be seen at the surface of the joint and subsequently
smoothed
• Do not apply if temperatures are below 40 degrees F
• Under normal conditions assembly is cured in 24 to 48 hours
FIREBRICK COLORS & SIZES
Firebrick used must comply with ASTM standards C1261 and C27 and meet or exceed the requirements of local,
national and international building codes regarding fireplace and chimney construction and the National Fire
Protection Association NFPA-211. A compliant firebrick lining is a minimum of 1
¼
” or 2
½
”. Although you can use
either firebrick thickness to line the sides, back and floor of the firebox, FireRock recommends using the 2 ½ ” thick
firebrick to line the floor. Note: True opening size is achieved using 1
¼”
brick on sides. For your convenience,
FireRock stocks firebrick in 3 sizes and two colors to accommodate the most popular firebrick patterns.
• Colors: Red and Buff
• Full Firebrick dimensions: 4” (W) x 9” (L) x 2
½
” (D)
• Split Firebrick dimensions: 4” (W) x 9” (L) x 1
¼
” (D)
• Soaps (Buff color only): 2
¼
” (W) x 9” (L) x 1
¼
” (D)
FIREBRICK PATTERNS
FIREBRICK
& MORTAR