FireRock 3620 Avenue C, Руководство по эксплуатации продукта

Страница: 104 / 124

104
CLEARANCES
Always allow at least a 2-inch clearance
between DuraChimney II pipe and any
combustible materials. Never fill any required
clearance space with insulation or any other
materials. Combustible materials include
lumber, plywood, sheetrock, plaster and
lath, furniture, curtains, electrical wiring, and
building insulation.
PERMITS
Contact your local Building Official or Fire
Official regarding permits, restrictions, and
installation inspections in your area.
CHIMNEY APPLICATIONS
DuraChimney II is a complete chimney
system tested and listed to test procedures
UL 103 and ULC S604. In the United
States, DuraChimney II can be used with
masonry fireplaces or appliances fueled by
oil, gas, coal, or wood that have been tested
and listed for use with a UL 103 chimney
system. In Canada, DuraChimney II can be
used with listed oil & gas fired appliances or
wood-burning fireplaces requiring a Type A
Chimney, in accordance with ULC S604. Do
not use with forced draft or positive-pressure
appliances. The DuraChimney II system is
designed to extend vertically with a maximum
of one (1) offset (two elbows total) of 30° from
vertical. DuraChimney II is listed under UL re-
examination Service number Mh7399.
EQUIPMENT & MATERIALS
Drill / Driver
hammer
Caulking Gun
plumb Bob
Screwdrivers (phillips & Standard)
Tin Snips
Saber or Keyhole Saw
Level
Dependable Ladder
Tape Measure
proper Gloves and Shoes
eye protection
Materials You May Need:
non-hardening Waterproof Sealant
8-penny nails, 600
O
F rTV Silicone Sealant
Roofing Nails
#8, 2-1/2” & 1-1/2” Wood Screws
INSTALLATION NOTES
proper planning for your DuraChimney
II installation will result in greater safety,
efficiency, and convenience, as well as
saving time and money. you must use only
authorized DuraChimney II parts to maintain
a listed chimney system. Do not mix parts
or try to match with other products or use
improvised solutions. Do not install damaged
or modified parts. Practice good workmanship.
Sloppy work could jeopardize your chimney’s
safety. Keep electrical wiring and building
insulation away from all chimneys. When
deciding the location of your chimney, try to
avoid modifications to roof beams and other
structural components of the building. If you
have any questions, contact either your dealer
or Simpson Dura-Vent directly.
CHIMNEY DIAMETER
Follow the fireplace manufacturer’s manual
to determine required chimney diameter and
clearances between combustible materials and
your fireplace. Never use a chimney with an
inside diameter smaller than your flue opening
above firebox unless specifically allowed by the
fireplace manufacturer. If you are connecting to
a masonry fireplace, refer to Table 2 (pg 11) for
proper sizing. To calculate the chimney’s outside
diameter, add 3 inches to the inside diameter.
103