Firepower MST 220i, Руководство по эксплуатации

Страница: 58 / 96

FIREPOWER MST 220i
INSTALLATION/SETUP 3-28 Manual 0-5343
3.23 Setup For STICK (SMAW) Welding
A. Connect the Electrode Holder lead to the positive welding terminal (+). If in doubt, consult the electrode manu-
facturer. Welding current flows from the Power Source via dinse type terminals. It is essential, however, that
the male plug is inserted and turned securely to achieve a sound electrical connection.
B. Connect the work lead to the negative welding terminal (-). If in doubt, consult the electrode manufacturer.
Welding current flows from the power source via dinse type terminals. It is essential, however, that the male
plug is inserted and turned securely to achieve a sound electrical connection.
C. Select STICK mode with the process selection control (refer to Section 3.10 for further information).
WARNING
Before connecting the work clamp to the work and inserting the electrode in the electrode holder make
sure the Electricity Supply is switched OFF.
CAUTION
Remove any packaging material prior to use. Do not block the air vents at the front or rear of the
Welding Power Source.
D. Switch the LOCAL/REMOTE switch inside the wire
feed compartment to LOCAL to use the Power Sources
Amperage control or REMOTE for remote amperage
control using a Hand Pendant Control.
Positive Welding
Terminal (+)
Negative Welding
Terminal (-)
Work Lead
Electrode Holder
Art # A-12539
Figure 3-23: Setup for Manual Arc Welding