Firepower FP-80, Руководство по эксплуатации

Страница: 15 / 42

Manual 0-2803 9 INTRODUCTION
SECTION 2:
INTRODUCTION
2.01 Scope of Manual
This manual contains descriptions, operating instructions
and basic maintenance procedures for the FirePower
FP-80 Plasma Cutting Power Supply. Service of this
equipment is restricted to properly trained personnel; un-
qualified personnel are strictly cautioned against attempt-
ing repairs or adjustments not covered in this manual, at
the risk of voiding the Warranty.
Read this manual thoroughly. A complete understand-
ing of the characteristics and capabilities of this equip-
ment will assure the dependable operation for which it
was designed.
2.02 General Description
The power supply provides 60 amp maximum output and
includes all control circuitry, electrical and gas inputs and
outputs, pilot circuitry, torch leads receptacle and a work
cable with clamp.
NOTE
The power supply can be ordered in various con-
figurations with various options factory installed.
A-02837
Power Supply
Torch and
Leads
Work Cable
With Clamp
Figure 2-1 FirePower FP-80 Power Supply
The power supply is designed to work with the Model
PCH-102 Plasma Torches. The torch includes a spare parts
kit which provides an assortment of replacement torch
parts.
NOTE
Refer to Section 2.04 for list of power supply op-
tions and accessories.
2.03 Specifications/Design Features
A. Power Supply Technical Specifications
The following specifications apply to the Power Supply
only:
1. Front Panel Controls
ON/OFF Switch, RUN/SET Switch and Output Cur-
rent Control
2. Front Panel LED Indicators
AC, TEMP, GAS, DC
3. Rear Panel
Input power cable strain relief, 230VAC input power
cable with plug, gas connection and Gas Regulator/
Filter Assembly
4. Input Power
Factory Supplied for:
208/230 VAC (±10%), 50/60 Hz, Single-Phase
Customer Selectable for:
208/230 VAC (±10%), 50/60 Hz, Three-Phase
380-415 VAC (±10%), 50/60 Hz, Single or Three-Phase
460 VAC (±10%), 50/60 Hz, Single or Three-Phase
575 VAC, 50/60 Hz, Three-Phase (see Note)
NOTE
Requires Optional 575V Transformer.
5. Output Power
Continuously variable from 15 to 60 Amps maximum
6. Duty Cycle
45% Duty Cycle @ 120V output with 60 Hz input
45% Duty Cycle @ 120V output with 50 Hz input
7. Cut Capacity
7/8 inch (22.2 mm); 1 1/4 inch (31.8 mm) severance
8. Pilot Circuitry
Capacitive Discharge (CD), Pulsed DC
9. Weight
72 lbs (32.7 kg)