FireplaceXtrordinair 36 ELITE-ZC, Руководство по установке

Страница: 18 / 24

P
AGE
18
I
NSTALLATION
( C
ONTINUED
)
Finalizing the Installation
! ACID WASH WARNING : Before installing the faceplate, make sure any masonry that has been
treated with acid wash has been properly neutralized (this is used primarily with brick faces). Acid
wash (muriatic acid) is used to remove excess mortar. If not properly neutralized with an ammonia
solution, the gold face may develop a permanent tarnish when the acid evaporates over time.
! WOOD SCRAP WARNING : Never burn wood scraps in the fireplace. Treated wood breaks down
the catalyst inside the fireplace, decreasing efficiency and increasing emissions.
1 Remove the set-up face using a phillips screwdriver included with the faceplate.
Use a phillips screwdriver to remove
the 10 screws holding the set-up
face in place.
Phillips
Screwdriver
2 Make sure the firebrick is properly in place.
3 Install the log retainer using the included 1/8" allen wrench.
4 Install the baffle, grate, and log retainer.
AAAAAAAAAAAAAA
AAAAAAAAAAAAAA
AAAAAAAAAAAAAA
AAAAAAAAAAAAAA
AAAAAAAAAAAAAA
AAAAAAAAAAAAAA
AAAAAAAAAAAAAA
AAAAAAAAAAAAAA AAAAAAAA
AAAAAAAA
AAAAAAAA
AAAAAAAA AAAAAAAA
AAA
AAA
AAA
AAA
AAA
AAA
AA
AA
AA
AA
AA
AAA
AAA
AAA
AAA
AAA
AAA
AA
AA
AA
AA
AA
Place the grate in the center
of the firebox.
Place the baffle on the brackets at
the rear of the firebox (the bend
goes upwards).
1/8" Allen
Place the log retainer into the
holders. Tighten down the set
screws in the holder with the
included 1/2" allen wrench.
Make sure the side and rear
firebrick is against the wall.