REV. A Page 7
FPB Pro Spur Burners Fire Pits with AWS System
GOE-30VDC Power Supply
AWS Burner Pan Assembly
Carton Contents
Hardware
Bag
REMOVING FIRE PIT ASSEMBLY FROM CARTON
The fire pit comes assembled and only requires a gas
connections after it is installed into the enclosure.
Open carton and remove contents. Inspect for any damage
or missing parts. The hardware bag includes the key valve
parts shown below in Fig.
Note:
Check for any gas leaks after gas is connect and
turned ON.
Fig. 4
Shows carton contents.
Note
: Round pan was illustrated for this drawing.
CAUTION:
Use dielectric grease on all wire nut connec-
tions and ¼” connectors to prevent moisture issues from
the outdoor environment.
The AWS system is polarity sensitive. There is a red
sleeve attached to the positive (+) side of the adapter.
When wiring the remote control receiver, one red wire from
the receiver connects to the adapter with the red sleeve.
The other red wire of the receiver connects directly to the
red wire from the gas valve control box. See Figs. 9 and
10 on page 11.
Carefully install the fire pit into the prepared enclosure,
connect the gas line and wire according to the figure
drawings in this manual.
Hardware Bag
(included with fire pit)
These fire pits includes a valve and control system that is
certified by Lab Test for USA and Canada to meet ANSI
Z21:.97-2014, CSA C22.2 No 3-M1998 (R2014)
Fig. 5
Hardware bag contents.
ON
OFF
