Doc.-No.: 01/EHTD400
Equipment Handbook
Date: 01.03.2003
TD400
Revision:
Rev. date:
Page: 13 of 40
FIREBIRD, Am Tower 16, 54634 Bitburg
7. Slider
The slider should be checked for damage to the fabric, the reinforcement tapes and the
seams. The grommets should have no sharp edges, must be tight and securely attached to
the slider.
8. Steering Lines
Check that the steering lines and secondary flairs run straight and orderly through the slider
and also through the small ring on the main riser and are correctly fastened to the steering
toggles. If the steering lines or secondary flairs are twisted, they should be straightened by
twisting in the opposite direction.
9. Main Risers
There should be no apparent damage to the material, grommets or rings of the main risers.
Check the performance of the Velcro and clean it if necessary.
10. 3-Ring System
The 3-ring system must perform flawlessly; the rings must be round and undamaged.
The closing loop should also show no apparent damage. The 3-ring system should funtion
with a light pull, as soon as the cable is released.
11. 3Ring Release System, Reserve Ripcord, RSL und Release Cable
Check that the release device as well as both release cables run freely and unobstructed.
The Velcro should be clean and close securely. The reserve ripcord cable should also run
smoothly and unobstructed in its housing. Check the function of the RSL, its attachment
points and the ease with which it is released and attached.
12. Harness, Hardware and Stitching
An examination of the harness, hardware and stitching can only be performed visually.
Pay attention that the type-7 webbing (with a yellow fiber running along the outside edges) is
not damaged and that no stitching is broken. All hardware must be free of corrosion and
move freely as designed.
13. Container Material
Examine the container for possible tears or separations. The grommets should have no
sharp edges or separation. The loop should be flawless. It is better to replace the loop too
soon rather than too late. The interior of the container should be clean.
14. Passenger Harness
An examination of the harness, hardware and stitching can only be performed visually. Pay
attention that the type-7 webbing (with a yellow fiber running along the outside edge) is not
damaged and that there are no broken stitches. All hardware must be free of corrosion and
move freely as designed. Check that the padding is in good condition and is easily moved.
Examine the attachment hooks for perfect functioning.
Should something unusual be noticed during the inspection,
contact the manufacturer immediately.
When it doubt - play it safe and contact us!
Doc.-No.: 01/EHTD400
Equipment Handbook
Date: 01.03.2003
TD400
Revision: 1
Rev. date: 01.12.05
Page: 13 of 40
