FireBird Enviroair 11kW, Руководство по установке и эксплуатации

Страница: 42 / 56

Firebird
Installation & Operation Manual
42
12. Wireless Intelligent Room Thermostat
DANGER
Adhere to the electrical standards in effect, as well as the
following points:
• It is imperative to switch off the supply for the sector to
which the product will be connected before proceeding to
installation. Risk of electric shock.
• Avoid positioning the receiver against or close to any metallic
part in order to avoid any radio transmission drop.
• Ensure that there is no dust on the connection points such
as the power terminals and / or on the cable. This may
cause a fire or electric shock.
CAUTION
• Avoid falls and collisions.
• Never attempt to immerse the product in liquid.
• Do not use abrasive products or solvents to clean the casing.
Its surface may be cleaned using a soft, dry cloth.
• Do not attempt to open the casing.
• Do not use this product outside. Do not place the connection
wire outside.
• All use or modification of the equipment not anticipated by
Firebird could lead to danger in using it.
• Use only the cables and accessories supplied.
NOTE
• Place the product in a detachable manner close to the device
to be controlled. The product should be installed at a height
of less than 1.5m high.
• Do not install the gateway where devices using radio
frequencies as means of transmission are prohibited
(refer to local standards in effect).
• Do not install the gateway close to devices that may be
affected by radio waves.
• Do not install the gateway where persons wearing a
pacemaker may be present.
• Do not install the gateway in a damp environment
(for example, a bathroom).
12.2 Factory Supplied Accessories
Description Quantity
Re Thermostat 1
Screw and plug 2
12.3 Installation Information
As these products communicate using RF technology special
care must be taken during installation. The location of the RF
components as well as the building structure may influence
performance of the RF system. To assure system reliability,
please review and apply the information given below.
Within a typical residential building the two products should
communicate reliably within a 30m range.
It is important to take into consideration that walls and ceilings
will reduce the RF signal. The strength of the RF signal reaching
the RF Receiver depends on the number of walls and ceilings
separating it from the Room Thermostat, as well as the building
construction. Walls and ceilings reinforced with steel, or
plasterboard walls lined with metal foil reduce the RF signal
significantly more.
12.4 RF Receiver Installation
1 Disconnect the main power from the system. To ensure your
safety, always make sure main power is switched off before
accessing wiring.
2 Remove the cover from the RF receiver.
12.1 Safety Summary