FireBird Enviroair 11kW, Руководство по установке и эксплуатации

Страница: 23 / 56

23
The electrical wiring connection for the outdoor unit is shown in figure below
9.2 Electrical Wiring Connection for Outdoor Units
9.2.1 Power and transmission wiring connection
Safety instructions
NOTE
Check the requirements and recommendations in the chapter
“9 ELECTRICAL AND CONTROL SETTINGS”.
DANGER
• Do not connect the power supply to the unit prior to filling
the space heating circuit (and DHW circuit if it were the
case) with water and checking water pressure and the total
absence of any water leakage.
• Do not connect or adjust any wiring or connections unless
the main power switch is OFF.
• When using more than one power source, check and ensure
that all of them are turned OFF before operating the unit.
• Avoid wiring installation in contact with the refrigerant pipes,
water pipes, edges of plates and electrical components inside
the unit to prevent damage, which may cause electric shock
or short circuit.
CAUTION
• Use a dedicated power circuit for the unit. Do not use a power
circuit shared with the outdoor unit or any other appliance.
• Make sure that all wiring and protection devices are
properly selected, connected, identified and fixed to the
corresponding terminals of the unit, especially the protection
(earth) and power wiring, taking into account the applicable
national and local regulations. Establish proper earthing;
Incomplete earthing may cause electrical shock.
• Protect the unit against the entry of small animals (like
rodents) which could damage the drain pipe and any internal
wire or any other electrical part, leading to electric shock or
short-circuit.
• Keep a distance between each wiring terminal and attach
insulation tape or sleeve as shown in the figure.