6
WIRELESSLY INTERLINKING
THE WI-SAFE 2 STROBE AND
VIBRATING PAD TO YOUR
WI-SAFE 2 SMOKE OR CO ALARM
It is recommended that you read through these “learn
in” instructions before starting.
Learning a Strobe into a new Wi-safe 2 system:
Learning a strobe into an existing Wi-Safe 2 system:
1. Place one of your Smoke or CO alarms on to its
baseplate. You will use this product to interlink with
the strobe to create a network.
2. Briefly push and release the learn button located in
a circular hole in the back of the Strobe, using a ball
point pen or similar pointed instrument (fig4).
1. Locate a Smoke / CO alarm that is already part of the
existing Wi-Safe 2 system. You will use this product
when adding the strobe into the network
2. Follow steps from point 2 above
3. After pressing this button, the two Alarm (red) LEDs
on the front of the unit will flash and then illuminate
for 5 seconds.
4. During this period, while the red LEDs are
illuminated, press the test/reset button on the
Smoke or CO alarm to wirelessly interlink the two
products.The Smoke alarm (or CO alarm) will emit
an audible signal, and the red (Alarm) LED on the
Smoke (or CO alarm) will also flash.
5. After learning in the Strobe and Vibrating Pad into
the alarms, test the units individually to ensure they
are wirelessly interlinked (see below)
To add any further alarms to the network, press the
learn button on the new alarm then the test button on
the Strobe, or on any alarm already learned in to the
network.
fig4
