11
INSTALLING THE STROBE
Make sure the Strobe is visible from anywhere in
the room.
To wall mount the Strobe drill two suitably sized holes
64mm apart, centre to centre, using the template (fig6)
(Warning - make sure that you check for electrical
cabling and pipework hidden in the wall before
carrying out any drilling). In the pack you will find two
screws and two screw anchors. Push the screw anchors
(if needed) into the drill holes and secure the screw
leaving the heads protruding so that the face of the
head is 5mm away from the wall. Now hook the Strobe
onto the screws (see below).
If placing the Strobe on a table
instead of mounting on the wall,
make sure it cannot be easily
knocked or slide off. The green
‘Power’ LED should illuminate
continuously to show that the AC
power supply is connected.
64mm
Drill hole spacing
fig6
