5
1.
Remove Shipping Disablement Ribbon
Warning
Your FireAngel has been shipped in a disabled state. You must completely remove the shipping disablement ribbon
before use. Failure to remove the ribbon will render the FireAngel inoperative in the event of a fire emergency
Note: Your fireangel may beep or start chirping once a minute on removal of shipping disablement ribbon. This is normal, read on for clarification.
2.
Locate Suitable Lighting Fixture
Important
Your FireAngel requires a mains supply of electricity to recharge the integral battery. Only install in suitable light fittings
that are used regularly. Your FireAngel requires the light to be switched on for a total of 1 hour per week to remain in
its fully charged state.
Please ensure your home’s electrical wiring is in accordance with BS7671.
a)
Orientation
Your FireAngel is only intended to operate with the bulb
underneath. Under no circumstances should your FireAngel
be installed upside down.
HOW TO INSTALL YOUR FIREANGEL
1. Hold FireAngel
3. Pull out from base
of alarm
2. Unplug ribbon
connector
4. Remove ribbon from
FireAngel & retain
(see page 20)
