I N S T A L L A T I O N
18.
INSTALLING THE REMOTE HEAD
One or two Remote Heads can be connected to the main base unit. The connections at the rear
of the unit are identical in function. CA Cables of the style and pin-outs as the audio CA Cables
will work to mount the remotes.
34. When mounting the Remote Head flush to a flat surface, use the unit as a template to
mark and drill (4) mounting holes 7/64" diameter for sheet metal screws or 5/32" for
machine screws.
35. The cable can exit the unit in (4) directions: Flush to the outside of the mounting plane
in the Up, Down and Right side direction or through the mounting plane out the Back.
When exiting Up, Down and Right, a small wire groove is provided.
36. Cut a small piece of plastic from the desired groove to clear the wire (Figure 20).
39. For inside installation mount the panel with (4) screws making sure the cable is not
pinched in the groove.
37. For an installation where the wire is to pass through the mounting surface, drill a 3/8"
hole and install the rubber grommet and pass the wire through.
38. Click the CA Cable into the modular jacks.
CA Cable
Connection
Cut one of
these areas out
(optional)
FIGURE 20
