S Y S T E M O R I E N T A T I O N
2.
SYSTEM OVERVIEW
This section provides an overview of the 3010R Series Intercom System and an introduction
to its individual components. Figure 2 shows a typical system. Refer to this diagram for
each component.
INTERCOM
The main control unit for the 3010R Series Intercom System which contains all the controls
and interface circuitry.
2-WAY RADIO
The existing 2-way radio in the apparatus.
MOBILE RADIO INTERFACE CABLE
Provides the interface connections between the 3010R Series Intercom Unit and the 2-way
radio in the apparatus. There are many different cable assemblies available; the particular
cable needed depends on the make and model of your radio. Contact your local Firecom
Dealer for more information regarding an Interface Cable specific to your radio.
POWER CABLE ASSEMBLY
Provides the power connections for the 3010R Series Intercom Unit. The power connections
should be made at the same place as the power connections for your radio.
HM-10 HEADSET MODULES
Headsets are plugged into the Headset Modules to interface them into the system. The
HM-10 is the standard Headset Module for use inside the apparatus.
PP-20 PUMP PANEL MODULE
A water-resistant Headset Module for use on the exterior of the apparatus (e.g. at the pump
panel, at the tail-board, etc.).
CA CABLES
Six-conductor flat cable which connects the 3010R Series Intercom Unit to the HM-10, PP-20
Headset Modules and the Remote Heads.
REMOTE HEADS
One or two Remote Heads can be connected to the main control unit to control the unit from a
remote location.
FIGURE 2:
3010R Series System Overview
PP-20 Pump
Panel Module
Remote Head
HM-10 Headset
Modules
CA Cables
Remote Head
CA Cables
+ 12 Volts DC
(Same as 2-way radio)
Power Cable Assembly
Mobile Radio
Interface Cable
2-Way
Radio
3010R Series
Intercom
R
Remote Head
R
