INSTALLING THE BATTERIES
Install the batteries on the proper compartment. Inspect batteries carefully before installing, thus making
sure that there are no cracks in the cases. Never add electrolyte if batteries have been in use for one
week or longer. For positive connections of the batteries, the surfaces which get in contact with them
should be clean. Apply a film of grease of vaseline to terminal clamps or connections. During transit,
the batteries may have lost some of their charge. If so, give a freshening charge before operating the
machine.
INSTALLING THE BATTERY CHARGER
Install the battery charger in a ventilated and dry place, far from heat sources and corrosive environ-
ments. Make sure that the voltages are correct (see the data plate located on the battery charger). Protect
the mains with a delayed switch or with a load fuse higher than the max. power consumption of the
battery charger. Observe the polarity of the battery socket (black cables are identified by s and
-).
BRAKE
The machine is equipped with parking and normal brakes. The normal brake is controlled by a pedal
located in the left side of the board (fig.). To operate the parking brake, fully press the pedal and lock
the lever (fig.) by pulling it .
CAUTION: the brake should be checked and adjusted at least once every three months.
FIG. 7
1) battery compartment
2) electric motor
FIG. 6
1) regolation front wheel brake
12
