FIOCCHETTI ECT-F TOUCH, Руководство пользователя и по обслуживанию

Страница: 9 / 56

9
4.2 POSITIONING
Incorrect positioning can cause damage to the appliance and create dangerous conditions for
users. Therefore, the installer must observe the following general regulations:
- make sure to maintain a minimum of 10 cm distance from the walls
- the room must be well ventilated
- keep the equipment far from heat sources
- avoid direct sunlight exposure and AC flow
- remove packing material
- remove accessories from the inside of the unit and the wooden pallet
below the equipment
- Position the appliance with the help of a spirit level. If necessary,
adjust the levelling feet of the unit (in the models fitted
with adjustable feet) (fig.1)
- remove the protective PVC film from the external surfaces of the unit
- clean the inside of the chamber with a cloth and alcohol in order to eliminate the
protective oil
Freezers glass doors (model Vision and Vision 2T) internal part has compulsorily to
be cleaned with a cloth and water.
Do not use chemical products.
4.3 WIRING AND ELECTRICAL HOOK UP
The electric installation and connection must be performed by qualified personnel. For safety
reasons the user must pay attention to the following indications:
- check that the electric installation is suitably sized for the absorbed power of the unit
- If the electrical socket and the plug of the power cord are incompatible, change the plug
with a suitable component, ensuring that the replacement part is approved, according to
the laws in force.
- do not use reductions or multi-way adapters
It is important to connect the appliance correctly to an efficient earth system, in compliance
with the relevant legislation.
If the power cord is damaged, it must be replaced by the manufacturer, by an authorized after
sale service or by a trained technician in order to avoid any possible risk.
4.4 SETUP OPERATIONS
To prevent errors and accidents, a series of checks for possible damages caused during
transport, installation and hook-up operations must be performed before connecting the unit.
4.4.1
Preliminary checks:
- check the condition of the power cord (it should not have cuts or chaffing)
-
check that the feet, door hinges and shelf supports are stable
-
check the condition of internal and external components (pipelines, heat exchanger
elements, fans, electrical components, etc.); check also that all parts are firmly fixed into
position
-
Check that the door gaskets and drawers have not been damaged (broken or
scratched) and that the doors close and seal properly.
-
Check that the TFT display is not damaged
While in use the equipment must be placed far from cross talks of engines,
generators, infrared rays, radio transmitters, telephones which may have negative
effects for the device.
Figure 1