Doc# 71-0170
4215-141
Rev. 02
12
08/23/2022
SL2 (SAUNALOGIC 2) CONTROL OPERATION
Operating Instructions for Heater
Default settings for temperature are preset to 194°F, the bath time is set to 60
minutes and 0-minute delay to start to heat. These settings are adjustable (as
described below) from 119°F to 194°F. Length of sauna can be set from 0 to
60 minutes. The time delay before start can be up to 24 hours. Any changes
are remembered by the heater for your next bath. Should the heater power
be lost then restored, the settings will return to their default values.
Starting Sauna Heater Immediately
Press the control POWER
icon to turn on the sauna control and heater.
The room temperature will be displayed on the control. The heater will turn
on and begin heating the room to current set points. Once the set
temperature is reached inside the room, the control will turn the heater on
and off again as needed to maintain the desired temperature. At the end of the selected time (60
minutes maximum), the control will turn itself off and the control display will turn off.
Setting the Time and Temperature
To set the sauna length time, press the
icon and then press the “"+" or "
-" icons to increase or
decrease time for desired setting. The maximum of time is 60 minutes.
To set the temperature, press the and next "+" or "-" icons to increase or decrease temperature for desired
setting. The maximum temperature is 194°F (90°C).
Note: Typical sauna bathing set-point temperature is 150°F to 165°F on the control.
Pre-Set Delayed Start
Press the
icon and delay time will appear in the display and will toggle between “dlay” the amount
of
time remaining. The maximum of time is 24 hours. If no delay is desired, press
icon to toggle off the
function.
Operating Instructions for Lighting
Press
icon to cycle through lighting options. Press and hold the
icon for 3 seconds to turn off the lights.
Lights will turn off automatically 10 minutes after sauna cycle is completed.
Color sequence
–
White
–
Red
–
Green
–
Blue
–
Yellow
–
Aqua
–
Purple
–
Rotation of Colors
–
Off
Choose the color of choice. Set lighting brightness. The brightness will be on display for 3 seconds. Press
the “
+
” or “
-
“icon to increase or decrease the light setting. Setting options are 25, 50, 75, and
100% light
output.
