71-0163
Page 4
4215-138
Rev. 01
09/07/2021
INSTALLATION OF SAUNA ROOM
1.
Position the base frame (or optional floor panel) in the desired location
on a level surface.
2.
Fasten the corners of the base frame using one 3” screw at each corner
in the predrilled holes.
Note: Predrilled holes are purposely made at an angle.
Note: The base must be level before installing wall and
ceiling panels. If the surface is not level, you may need to
shim the floor panel to get it level.
The base is numbered to correspond with the panels for correct locations. The right wall panel is labeled
#1, the back wall panel is labeled #2 and etc…(See picture below)
3.
Place the right-side wall panel on the outer edge of the corresponding floor
panel.
Optional Floor Panel
