Finn HydroSeeder T280, Руководство по эксплуатации и каталог запасных частей

Страница: 29 / 84

TROUBLESHOOTING YOUR HYDROSEEDER
®
:
Problem Probable Causes Suggested Solutions
Pump loses prime - lacks Too much agitation Slow the agitator
distance - leaves excessive Pump worn Reset pump tolerance page 32
amount in tank (100 gal Suction partially plugged Clean out machine see pages 26-27
(378 liters) or more) Nozzle worn or plugged Clean nozzles, replace if necessary
Fertilizer Change type
Clutch slippage Readjust clutch - see clutch manual
VALVE:
Valve stuck Frozen Thaw out ice & lubricate - leave in
discharge position during storage
Constant plugging during Foreign material in slurry Drain and clean out tank - check
operation storage for foreign materials
Constant plugging during Loading HydroSeeder® before Reinstruct your operator - see
loading and discharging tank is half full of water pages 17-18
Incorrect loading procedure See loading procedure pages 17-18
Improper operation by operator Reinstruct your operator -
Review Operator’s Manual)
Clutch slipping Readjust clutch see manual
Not moving valve handle Valve should be fully open
far enough
Machine not being flushed out See page 17
prior to reloading
Machine not being run at Reinstruct your operator - see
correct RPM during loading page 17
Extension hose plugs after use Letting water run out, leaving If hose has to be uncoupled, seal ends
wood fiber mulch to dry out to keep water in hose and prevent
wood fiber mulch from drying out
CLUTCH:
Does not pull load or overheats Out of adjustment Readjust clutch, instructions in
manual
Jumps out of engagement Too loose or too tight Readjust clutch - see manual
PUMP:
Excessive wear Fertilizer with highly abrasive fillers Change fertilizer - avoid abrasive
fillers
Overloading machine with dry Load machine to recommended
material capacities
Too much time allowed between After loading and mixing has been
loading and and discharging completed, set agitator at 1/2 speed
in reverse and disengage pump
Recirculating all the time Close recirculation valve when
discharging through the boom
25