12
Inline Post Filter(s) - Remove the collet clips from the fitting and using
the quick release, remove the tubing on both sides. (Lift filter off
bracket if easier).
Un-screw the fittings from the end of the inline filter. Dispose of
exhausted filter. Remove any residual PTFE tap from the male thread
of the fittings. Using the PTFE tape provided with the unit, thread 15-
20 wraps of PTFE tap around the male end of both fittings.
Remove the new inline filter from the packaging and screw the fittings
back in place. Ensure the filter is the correct way by the flow arrow.
Put filter back in place and re-insert the tubing and collet clip and pull
back to ensure inserted correctly.
Now carry out 1
st
System Flush. (2
nd
flush not required unless the
membrane is replaced, see Replacing Filters and Membrane).
Carefully add membrane back into the housing.
Replacing Filters and Membrane(s)
–
Please carry out all steps from the Replacing Filters section and carry
out the 1
st
flushing stage.
Follow the instructions for inserting your membrane, then carry out
the 2
nd
flushing stage to complete the filter and membrane changes.
