Fimap SMG130 S, Руководство по эксплуатации и обслуживанию

Страница: 41 / 48

41
TROUBLESHOOTING
59. ELECTRIC FUSES AND THERMAL CUT-OUTS
The machine is fitted with the following electrical protection systems:
Power fuses arranged in the electrical box, to protect against short-circuiting
thermal trip units arranged on the outside of the handlebars, to protect the following engines:
1. 25 A trip unit for left suction motor
2. 25 A trip unit for right suction motor
In the event of malfunctioning, check a thermal cut-out has not intervened. If the engine overheats, its
thermal cut-out intervenes to block the electricity supply. Wait a few minutes until it has cooled down, then
press the specific circuit breaker button to reactivate the power supply and engine operation. If the problem
persists, contact the specialist technical assistance centre.
60. THE AUTOMATIC WATER/DETERGENT DOSING SYSTEM DOES NOT WORK
The automatic water/detergent dosing system has been designed with criteria of extreme sturdiness and
reliability, but there is a special by-pass system that allows you to use the machine even if the system is
out-of-use.
To by-pass the automatic water/detergent dosing system, you must rotate the tap lever (1) on the front of
the machine in an anti-clockwise direction; in this way you can go on working even with the system out-of-
use. Remember, however, to put not only water in the solution tank, but the right quantities of both water
and detergent. With the dosing system out-of-use, the water flow is regulated via the tap on the steering
column.
Contact an Authorised FIMAP Retailer to have the system repaired.
61. ALARMS
The machine is fitted with a flashing blinking light (1) for diagnosing faults in the traction motor control
system. Each sequence (number of consecutive flashes) indicates a particular type of fault. When flashing
begins (with an accompanying operating fault), you should contact the technical assistance centre,
specifying the number of flashes.
1
1