Fimap SMG130 S, Руководство по эксплуатации и обслуживанию

Страница: 17 / 48

17
PREPARATION OF MACHINE
To connect the battery charger you must:
1. Move the machine near to the battery charger
2. Make sure that the key switch in the “0” position
3. Engage the parking brake
4. Grip the seat rotation uncoupling handle (1), move it forward as far as it will go
5. Rotate the seat support as far as it will go
The coupling connector of the battery charger is supplied inside the bag containing this instruction booklet,
and must be fitted to the battery charger cables as shown in the instructions.
ATTENTION: This process must be carried out by qualified personnel. An
incorrect connection of the connector may cause problems with machine
functioning.
6. Open the hatch (2) and connect the recently wired cable to the external battery charger
7. When the recharge cycle is complete, disconnect the battery charger cable from the machine
ATTENTION: carefully read the use and maintenance instructions of the
battery charger that is used for charging.
ATTENTION: Keep the seat support lifted for the duration of the battery
recharging cycle to allow gas fumes to escape
ATTENTION: Danger of gas exhalation and leakage of corrosive liquids.
ATTENTION: Danger of fire: keep naked flames at a safe distance
14. BATTERY CHARGE LEVEL INDICATOR (BATTERY VERSION)
The battery indicator uses LEDs and has 8 positions (7 yellow - charged batteries, and 1 red - run down
batteries).
ATTENTION: A few seconds after the red indicator light comes on, the brush
motor switches off automatically. With the remaining charge it is still possible,
however, to complete the drying process before recharging
15. SERVICE BRAKE – PARKING BRAKE
The machine has an electronic braking system. To brake in normal conditions, just remove your foot from
the accelerator pedal. If this service brake is working badly, or if necessary, activate the brake pedal (1)
pushing it downwards.
1
2
1