Filtration Group FG Fluid Solutions AF 73-76 S, Перевод оригинальной инструкции с инструкцией по сборке

Страница: 12 / 24

Page 12
Translation of the original instructions with assembly instructions AF 73 - 76 S/AF 93 - 96 S, Filtration Group GmbH, 11.07.19,
Mat. No. 79301615, Version 13
13 Troubleshooting
Fault Possible cause Remedy
Gear motor
does not turn Motor fuse tripped
RESET motor fuse
Check gear motor
Filtrate solidified Clean filter
Valve does not
open
Compressed air
pressure too low Increase pressure
Pilot valve
defective Check pilot valve
Pilot valve not
connected
correctly Check electrical
and pneumatic
connections
Initial
differential
pressure no
longer obtained
Solids
concentration too
high Improve
prefiltration
process
Gear motor
rotating in wrong
direction Check direction of
rotation
Cleaning time too
short Prolong cleaning
time (min. gear
motor speed: 1-2
revolutions)
Increased
concentration
of dirt on clean
side Filter element
defective Check filter
element and if
necessary renew
Seals brittle Check seals and if
necessary renew
Leakage rate at
shaft seal too
high
Gear motor
does not turn Tighten shaft seal
and if necessary
renew
14 Maintenance
DANGER!
Explosion hazard!

Risk of injury to persons or damage to
property.

Work is only allowed to be carried out in
hazardous areas if appropriate safety
precautions are implemented.

Safety precautions must be implemented
by the owner.
WARNING!
If the system is maintained by unauthorised
persons

Risk of injury

All warranty claims are rendered invalid

The system must be maintained by a suitably trained
person!
Before all maintenance work:

Shut down the metal-edge filter (section 12).

Take steps to prevent the machine/system from being
switched on again by unauthorised persons.

Wear protective clothing and equipment appropriate to
the hazard potential of the medium (e.g. goggles,
respirator, protective clothing, etc.).

Carry out the maintenance work.

Start up the metal-edge filter again (section 10).