Filtration Group FG Fluid Solutions AF 73-76 S, Перевод оригинальной инструкции с инструкцией по сборке

Страница: 8 / 24

Page 8
Translation of the original instructions with assembly instructions AF 73 - 76 S/AF 93 - 96 S, Filtration Group GmbH, 11.07.19,
Mat. No. 79301615, Version 13
9.1 Mechanical installation
DANGER!
Explosion hazard!

Risk of injury to persons or damage to
property.

Check the conductivity between all
components!

Note the maximum permissible resistance:
R < 10

.

Make sure that earthing is provided by the
customer.
It must be possible to remove the filter insert
in order to carry out maintenance work.

Prepare a suitable seat on which to mount the filter
(e.g. supports).

Be sure to allow the required height for dismantling and
draining (see data sheet).

Replace two opposite screws at the flange cover of the
metal-edge filter by lifting screws.

Lift metal-edge filter at the lifting screws out of packaging.

Bolt the metal-edge filter to the prepared seat.

Remove the caps from the connections.

Connect the pipes.
Pressure relief

Design measures must be incorporated to prevent
inadmissible excess pressure on the dirty side.

Install a pressure relief device if necessary.
Fig. 6: Mechanical installation
9.2 Special mounting instructions for the drain
pipe
WARNING!
The full inlet pressure is present at the drain valve!

Make sure that the drain pipe is securely fastened.

Do not drain concentrate into the atmosphere.

Provide splash protection if necessary.

Lay the pipes without a syphon if possible.
Watch out for clogging as a result of sedimented
concentrate!
9.3 Electro-pneumatic connections
DANGER!
Danger of electric shock!

Risk of serious or fatal injury in case of
contact with electrical components.

All electrical installation work must be
carried out by a suitably qualified
electrician.
9.3.1 Connection to customer's control
Gear motor

See the rating plate or the contract documentation for the
connection data (please also refer to the connection
diagram for the terminal box).

Connect the gear motor .

Provide adequate protection for the motor.
Fig. 7: Connection of the standard gear motor
Differential pressure switch (optional)

Refer to the enclosed manufacturer’s documentation for
details of the connections.
Automatic drain valve (optional)

Provide a suitable compressed air supply.

Provide a suitable 5/2-way valve for pilot control.
Refer to the contract documentation for
special types.
Dismantling height
Draining height
(400 -600 mm)
Filtrate
Inlet
Drain
400V 3~ 230V 3~