Fieldmann FDN 3025-A, Руководство пользователя

Страница: 9 / 80

EN
4V CORDLESS NAIL GUN USER’S MANUAL
Operation
9
Open de cartridge shaft (2) by slightly pressing the reload lever (1).
Pull the reload lever backwards to open the cartridge shaft (2).
For nails:
Place the nails upside down against the left side of the cartridge shaft (2). The left side also shows a nail-
symbol on the cartridge shaft, see fig.D.
For staples:
Place the staples upside down in the cartridge shaft (2).
Push the reload lever to fully close the cartridge shaft.
Before loading the tacker, make sure the machine is in “0” position.
Never load staples and nail at the same time.
Checking the cartridge shaft
The cartridge filling level window (7) indicates the amount of staples/nails inside the cartridge shaft.
Using the tacker
After every load test the machine on a piece of scrape.
Press the “0/I” switch (4) to “I” to unlock the machine.
Press the “0/I” switch (4) to “0” to lock the machine.
Note: When not in use, press the “0/I” switch to “0” to lock the machine.
Note: Always store in Lock on “0” position.
Placing the tool
1. Place the tool on workpiece at the spot where the staple or nail should be located.
2. Press the tool down fi rmly by pressing the machine on the top (5) with one hand.
3. Use your other hand to operate the switch (3).
4. By pressing the machine down firmly you lift the safety of the machine.
WARNING!
The safety of the machine will be lifted when pressure is applied to the safety pin (6) on
the bottom of the machine. Always make sure the tacker mouth is in direct contact with
the material when pressing the switch
.
Stapling
Press the switch (3).
The tool will cause a rebound because of the impact it operates with. Keep this in mind. For long nails and
staples this can cause wrong stapling or nailing. When backpressure is applied wrong stapling or nailing
can be avoided.