Fieldmann 50004955, Руководство пользователя

Страница: 14 / 21

EN
20V AIR COMPRESSOR USER’S MANUAL
15
Position air chuck clamp in the unlock position perpendicular to the high pressure air hose.
Place air chuck on valve stem.
Push air chuck down so that the threaded section of the valve stem is inside the air chuck.
Clamp the end of the air chuck down onto the valve stem by pressing air chuck clamp down until it stops or
is parallel with the high pressure air hose.
NOTE:
The pressure readout on the gauge while infl ating is a measurement of the fl uctuating pressure between the item
and the high pressure hose. To get an accurate reading, stop infl ating and follow above instructions for reading
the air pressure.
AUTOMATIC SHUTOFF
The digital gauge will remain on for up to fi ve minutes. To manually shut off, press and hold the mode button until
the light turns off then release the button.
INFLATING WITH THE LOW PRESSURE HOSE
See Figures 7–8.
The low pressure hose is used to infl ate low pressure items, such as air mattresses, pools, and fl oats.
NOTE:
A pinch valve adaptor comes as part of the small infl atable nozzle assembly that is attached to the end of the low
pressure hose. The pinch valve adaptor is used for items that have a smaller air opening or pinch valve. Insert
pinch valve adaptor into pinch valve, insuring that the tip of the adaptor is inserted past the inner “fl ap” inside the
valve. When infl ating, ensure that the tip is not blocked during infl ation.
Align the slots in the hose with the pins on the sides of the infl ator.
Turn the hose clockwise as far as it will turn.
Press the low pressure (I) switch to start infl ating.
When the desired pressure is reached, turn the switch off.
Remove the hose by turning it counterclockwise as far as it will turn and removing it from the infl ator.
Store the hose in hose wrap on the left side of the product.
NOTE:
Always leave low pressure hose free of obstructions and with pinch valve adaptor off when not in use.
Overheating could occur low pressure hose is blocked.
DEFLATING WITH THE LOW PRESSURE HOSE
See Figure 8.
The low pressure hose, when placed In the defl ator, can be used to remove air from Infl ated items.
Place the hose Inside the defl ator.
Press the low pressure (I) switch to start defl ating.
When the item has been defl ated, turn the switch off.
Remove the hose by pulling if from the defl ator.
Store the hose in hose wrap on the left side of the product.
OPERATION