FIC A360 Reference and, Справочное и сервисное руководство, Страница: 54 / 187

Installation and Upgrade
7. Remove CPU and insert the preferred CPU.
8.
Use a flat screw driver and insert it into the other side of CPU socket and tilt it towards
LCD panel to unlock CPU from the socket. It’s recommended to use the protective
tooling securing CPU against damage.
9.
Place back the heat plate and keyboard cover. Boot on the computer, and then BIOS will
automatically detect the type of the CPU which just be installed.
2.3.3 Memory Upgrade Procedure
The notebook computer offers two 64-bit memory slot using 144-pin SODIMM (Small
Outline Dual Inline Memory Module) at 64MB, 128MB, and 256MB SDRAM. Two memory
slots are found inside the memory compartment. The memory compartment is located on the
underside of your computer inside the memory compartment. The notebook has no memory
on-board so you should have at least one SODIMM module inserted. With two memory slots,
you can have several combinations up to 512MB.
n
/
r
Tilt Foot
o
Memory Compartment
p
Battery Release Latch
q
Battery Bay
s
Mini-PCI Socket Compartment
Figure 2-7 Memory Compartment Door
Using the Memory Slot inside the Memory Compartment
Follow the steps below on how to upgrade the memory modules:
1.
Make sure the system is powered off and that no peripheral devices are attached.
2.
Turn the system over and locate the screw on the memory compartment.
3. Remove the screw and open the memory compartment. Locate the alignment notch on the
module.
4.
Locate the memory module socket. Align the notch with the notch in the socket connector
and insert the module as follows:
−
Hold the SODIMM at a 60-degree angle and align the SODIMM connector with
the socket in the system. Push the connector into the socket.
−
Press down on the edge of the SODIMM until the locking tabs on the sides snap
into place, securing the module.
FIC A360 Service Manual 2-15