FibroLAN MCM1000L-LX1-2, Руководство пользователя и инструкция по установке

Страница: 19 / 20

MCM1000S/L GBE module
09
If the problem persists after carrying out the above procedure, do the following: exchange
suspected MCM1000S module with another similar module, and check connectivity
and mode of operation. If that has solved the problem, send your MCM1000S for repair. If
the problem still persists, there is probably some sort of general network failure. Call your
local Fibrolan dealer or our technical support. (
support@fibrolan.com
Make sure to provide the following information:

Date and place of purchase, from whom, original invoice

The serial number of the MCM1000S module and its Firmware revision

The serial # of the MetroStar™ including type of the installed modules.

The configuration of the equipment that is connected to the MetroStar
™
and the
sequence of events leading to the problem.

Actions already taken and status files.

Software revision levels of the installed equipment.
15
– Specifications
Standard Compliance
IEE 802.3 2000 edition, 1000Base-SX 1000Base-LX, IEEE802.3z
Conversion Method: Digital Conversion
Management:
SNMP management via MetroStar management module
–MMM-01
F/O ports
Port 2: Duplex SC, S/M fiber, 1310/1550nm, 1000Base-LX (10/20/40/80/120 Km)
Port 1: Duplex SC, M/M fiber, 850nm, 1000Base-SX, (220m)
For Fiber optic specifications for each MCM1000S model, refer to “ section 7 “ Fiber Optic
Connections
Diagnostic LEDs:

Link, Activity (Tx or Rx), LB (loop-back), LST LEDs for F/O port 1

Link, Activity (Tx or Rx), LB (loop-back), LST LEDs for F/O port 2

MA Active (indicating MCM1000S connected to a remote MA active device) Common
LED

Power: power on / off (PWR LED)
DIP switches (mother board) per port
LST (Link Segmentation Test) Normal / Test mode (Down/Up)
LB (loop-back) enable / disable (Up/ Down)
The active Ma™ Management overrides the DIP switches setting
Management of Remote Devices: via MA
™ Technology
SLE mechanism enabled/disabled thru MMM-01 management module
Specifications are subject to change without prior notice
Module default settings
Downstream bandwidth 1000Mbps
Channel enabled
LST enabled both ways (LST ON)
LB disabled both ways
SLE disabled both ways
No channel description