The copyright of this document is owned by Fibocom Wireless Inc., and the document shall not be replicated without approval.
SC806Hardware User ManualPage4 of 70
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and
users, and the Max allowed antenna gain is as following table showed:
Operating Band
Antenna Gain
（
dBi
）
WCDMA BAND II
8.05
WCDMA BAND IV
5.50
WCDMA BAND V
12.1
LTE BAND 2
8.55
LTE BAND 4
6.00
LTE BAND 5
12.6
LTE BAND 12
12.6
LTE BAND 13
12.6
LTE BAND 17
12.6
BT/WIFI Test Gain
Antenna Gain
（
dBi
）
2.4G WiFi
2.5
WIFI 5G
2.1
2) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions
above are met, further transmitter test will not be required.
However, the OEM integrator is still responsible for testing their end-product for any additional compliance
requirements
required with this module installed
Host manufacturer is responsible for ensuring that the host continues to be compliant
with the Part 15 subpart B unintentional radiator requirements after the module is
installed and operational.
IMPORTANT NOTE: In the event that these conditions can not be met (for example
certain laptop configurations or co-location with another transmitter), then the FCC
authorization is no longer considered valid and the FCC ID can not be used on the final
product. In these circumstances, the OEM integrator will be responsible for re-evaluating
the end product (including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed such that
20 cm may be maintained between the antenna and users. The final end product must be labeled in a
visible area with the following:
“
Contains FCC ID:
ZMOSC806AM
”
.The grantee's FCC ID can be used
only when all FCC compliance requirements are met.
