Connection with gate opener
Smart Implant can be connected to different devices to control them. In this example it is connected to gate opener with impulse input (every impulse will start and
stop the gate motor, alternately opening/closing).
1. Disconnect Power
2. Connect with the diagram below
3. Verify the correctness of connection.
4. Power the device.
5. Add the device to the Z-Wave network.
6. Change values of parameters:
Connected to IN1 and OUT1:
Change parameter 20 to 2 (monostable button)
Change parameter 156 to 1 (0.1s)
Connected to IN2 and OUT2:
Change parameter 21 to 2 (monostable button)
Change parameter 157 to 1 (0.1s)
Inclusion/Exclusion
On factory default the device does not belong to any Z-Wave network. The device needs to be
added to an existing wireless network
to communicate with the
devices of this network. This process is called
Inclusion
.
Devices can also be removed from a network. This process is called
Exclusion
. Both processes are initiated by the primary controller of the Z-Wave network. This
controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.
Inclusion
1.Power the device.
2.Set the main controller in (Security/non-Security Mode) add mode (see the controllers manual).
3.Quickly, triple click button on the device housing or switch connected to IN1 or IN2.
4.If you are adding in Security S2 Authenticated, scan the DSK QR code or input the 5-digit PIN code (label on the bottom of the box).
5.LED will start blinking yellow, wait for the adding process to end.
6.Successful adding will be confirmed by the Z-Wave controllers message. To add the device to the Z-Wave network using
Exclusion
1.Power the device.
2.Set the main controller into remove mode (see the controllers manual).
3.Quickly, triple click button on the device housing or switch connected to IN1 or IN2.
4.LED will start blinking yellow, wait for the removing process to end.
5.Successful removing will be confirmed by the Z-Wave controllers message.
Product Usage
Tips for arranging the antenna:
Locate the antenna as far from metal elements as possible (connecting wires, bracket rings, etc.) in order to prevent interferences,
Metal surfaces in the direct vicinity of the antenna (e.g. flush mounted metal boxes, metal door frames) may impair signal reception!
Do not
cut or shorten the antenna - its length is perfectly matched to the band in which the system operates.
Make sure no part of the antenna sticks out of the wall switch box.